Is not limited to upgrade my batteries capacity. The standard flashing procedure should work successfully with the caveat of some platform specific problems as noted below. The image can be flashed by using a USB to UART adapter connected to the main port when the CC3D is put into the STM32 bootloader mode, achieved by powering on the CC3D with the SBL/3.3v pads bridged. Connecting to CC3D First, you need to use different connector.
If it landed kind of using the all needed cables. Open the STM32 Flash downloader, and select the appropriate COM port.Cleanflight can be used on multirotor aircraft and fixed-wing aircraft, it supports a variety for shapes and motor counts, not limited to quadcopters, hexacopters, octocopters, tricopters and planes.Now connect your flight controller to your PC via USB.If you see the Red or Green LED’s then try again untill only the blue LED is on, then you can proceed to the next step. Assuming this was done correctly you shoud only see the blue LED.
Dont solder these two connectrions together as you only need to short hte boot pins on initial power up. I suggest using some metal tweezers, or a paperclip. In order to to upload new firmware you need to first short the boot connector on your flip32 or naze32 flight controller which shown in this image.hex file in the obj folder once you have downloaded the firmware from github. You will need to download the STM32 Flash Downloader Demonstrator tool. In this example I am using the baseflight firmware, but if you prefer to use the cleanflight software just use the appropriate. This is usually caused by a bootloader problem No reponse from the bootloader, programming: FAILED
If you had problems loading the firmware using the config tool then you will need to load the firmware using the STM32 flasher. Option 2, if you have problem using the config tool
0 kommentar(er)
